After the flatbed trailer enters the water, pay attention when handling it. If the water enters and turns off during the wading process, you should immediately turn off the ignition switch and move the vehicle to a place where there is no water, so that water enters and exits the exhaust pipe to avoid damage to the three-way acceleration.
If water enters the inside of the mover, the spark plug should be removed, cut off the fuel supply system and the ignition system, and the mover should be operated by a motor so that the water entering the inside of the mover can be drained smoothly. Check the system of the vehicle. Oil condition, and replace bubbling and turbidity in time.
After the test, use compressed air to clean the electrical connection parts in the mobilization engine room to avoid damage caused by the accumulation of water in the electrical connection parts. After the cleaning is completed, conduct a road test of the vehicle to confirm that there is no abnormal noise during driving. If there is obvious driving noise, Check the bearings and rotating parts of the mover.
Due to the strong water absorption of glue in interior decoration materials, the glue should be removed and placed in a wider space to facilitate the evaporation of water. It should be noted that the air conditioner should be turned on and the vehicle cycle switch should be adjusted to the internal cycle to facilitate the Water vapor can be discharged through the air conditioning system.
